Modding Q&A

[Vøytek]

You didn't connect them properly (red-red).

[yang20]

You MUST connect between green-green or red-green. You cant connect red-red. To change place of red node use other origin. ALWAYS connects with ALT clicked. It'll give you 100% sure of correct connection.

[StoneCrafter14]

Thank you for your Answers
I connected it red-green and green-green and it didn't work.
I fixed the problem by myselfe ... I had to create new roads at the right end of the prefabs

But thank you for your Support

[yang20]

Right, sometimes connection prefab-prefab not correct properly (f.e. holes between prefabs). In that case you should place short road as something like patch.

[MandelSoft]

You could also check all the connections and use ALT key while using the move tool to force the connections.

[Gman912]

Going back to the semaphore question: Say I want a German one and it only comes up a Dutch one, how do I get that country's one to appear?

[Vøytek]

If you place a prefab in Germany and enable semaphores - German traffic lights will appear. It depends on the country.

[Gman912]

This one I can't solve. How can I 'paint' the texture on a gas station prefab? I want to go from a dirt texture to a grass texture.

[yang20]

You should have this option on 'Node properties'. Try to change something like grass, or default to option like desert. I dont on map editor so I cant say more exacly.

[Vøytek]

You can't use brush on prefabs, unfortunately.