Page 1 of 6

[REL] Highway assets 1.02

Posted: 17 Jan 2015 18:29
by plykkegaard
Kwazar Corporation

Antiglare panels protect drivers from the flash of lights from cars going in the opposite direction. They can be used on dual carriageways in places with increased danger of light glare (dazzle), amongst other: road curves, exits, flyovers, bridges, etc. The panels are optionally 60cm, 90cm, 120cm high,
standard green, made of HDPE, durable material, resistant to outdoor conditions (sun, rain, wind, high and low temperatures). They can be mounted on standard crash barriers (steel and concrete).
http://www.kwazar.com.pl/1726,antiglare-panels.html

Blue Systems: SAFENCE median & side barrier

The side barrier is placed on the area at the side of the carriageway (on the hard shoulder). The median barrier is placed between lanes going in opposite directions both in the central reserve on a motorway or when the distance between oncoming lanes is small, for example when a 13 m wide road is rebuilt
into a 2 + 1 lane road. The median barrier is either placed in the base course or in the road paving.
http://www.bluesystems.se/products_medi ... ex_en.html

SAFENCE slope barrier is installed on an embankment slope. It is high enough to handle a car that flies off the road and over the slope, and at the same time low enough for a car that follows the slope of the embankment. Blue Systems supply slope barriers tested for EN 1317 N2-W6 and NCHRP 350 TL3.
SAFENCE EN 1317 slope barrier is installed with SAFENCE U posts, SAFENCE NCHRP 350 slope barrier is installed
with SAFENCE C posts (see above).
http://www.bluesystems.se/products_slope_index_en.html

Release history
hw_assets_1.00.scs: 25jan2015
- 3 railings 600, 900 and 1200 mm panels from Kwazar Corporation

hw_assets_1.01.scs: 10feb2015
- Added: Safeence cable barriers: I-post, C-post and U-post (3 cables)

hw_assets_1.02.scs: 14feb2015
- Added: Safeence cable barriers: I-post, C-post and U-post (4 cables)

Download: http://looksharp.dk/page/ETS2-Highway-Assets.aspx

In development:
-

Image

Re: [WIP] Highway assets

Posted: 17 Jan 2015 19:11
by KubaJAM
Nice, I'd like to see more of this kind of thing, maybe some continuous boarding as well ;).

Re: [WIP] Highway assets

Posted: 17 Jan 2015 19:15
by plykkegaard
Do you an example of this?
I assume it's screens between left and right lanes?

Re: [WIP] Highway assets

Posted: 17 Jan 2015 19:20
by ETS2-User
Wohow thank you so much for this, I was missing this for so long! :D :D

Re: [WIP] Highway assets

Posted: 17 Jan 2015 19:54
by volan123
Looks beautiful!! You always come up with good ideas :D

Re: [WIP] Highway assets

Posted: 17 Jan 2015 21:28
by jontsuba
Looks fine! And ProMods' people always say they are in dire need of modelers...

Re: [WIP] Highway assets

Posted: 24 Jan 2015 00:13
by plykkegaard
Progress so far

600 mm mounted back and front
900 + 1200 mm ready for mount
Image

Square steel tube is reduced to half the size - 5m model

Re: [WIP] Highway assets

Posted: 24 Jan 2015 00:15
by Rocar 512E
We need theese in Some countries!

Re: [WIP] Highway assets

Posted: 24 Jan 2015 00:19
by plykkegaard
These are from Polen, there's a lot of variants
I haven't seen them in Denmark though

Re: [WIP] Highway assets

Posted: 24 Jan 2015 00:22
by Rocar 512E
plykkegaard wrote:These are from Polen, there's a lot of variants
I haven't seen them in Denmark though
In Romania we have these, so that's why we need 'em ;)
Image