Going from dual carriageway to single carriageway in the UK
Posted: 01 May 2021 08:50
I want to extend an existing road (originally it went nowhere, a blocked route), I tried adding a dual to single narrowing prefab (UK) but it had the red/green nodules the wrong way around, how can I make them switch positions? I did set the left hand drive option, that looks fine.
What's the best workflow for adding roads - would it be best to start off with a straight road to the destination then add bends / height, or add bends / height as I go?
Also I couldn't find the matching pavement ending for this, there is a certain pavement on the existing road but the 'pavement ends' doesn't seem to have an option that matches so it suddenly changes to a different pavement style before ending, any help with this too please? Probably don't need the pavement there anyway but I do need to 'end' the pavement at some point so the problem would still exist.
Thanks!
What's the best workflow for adding roads - would it be best to start off with a straight road to the destination then add bends / height, or add bends / height as I go?
Also I couldn't find the matching pavement ending for this, there is a certain pavement on the existing road but the 'pavement ends' doesn't seem to have an option that matches so it suddenly changes to a different pavement style before ending, any help with this too please? Probably don't need the pavement there anyway but I do need to 'end' the pavement at some point so the problem would still exist.
Thanks!