Hi!
Entrance of the ferry port, the right side gate is in the middle of the inlet opening, it is should be moved to the right.
This is an old bug, so if it could be fixed in the next update, please?
- Real Full Trailer Combination Driver -
(1.83) Hirsthals, Denmark, ferry gate
-
- Posts: 202
- Joined: 13 Aug 2013 19:12
- Location: Nokia
- Real Full Trailer Combination Driver -
- Jan Verschueren
- Posts: 1860
- Joined: 17 Aug 2013 21:11
- Donation rank:
- Location: Linkeroever, Antwerpen
Can you explain what is wrong exactly, because it doesn't look misplaced to me. In fact I can't see how it could be placed differently.
Code: Select all
Coördinates... ; [21/12/2014 22:11] (sec+0000-0010);1188.44;-10.7652;-39098.8
"You know you've played too much ETS2 when..."
"Bad cop" forum moderator, if required.
"Bad cop" forum moderator, if required.
-
- Posts: 202
- Joined: 13 Aug 2013 19:12
- Location: Nokia
I'm Sorry.
I looked at that gate should be on the right stick to the fence, but there is a sliding gate.
But the gateway spacing, when you come away from the harbor, is a little cramped for long and wide transport.
- Real Full Trailer Combination Driver -
I looked at that gate should be on the right stick to the fence, but there is a sliding gate.
But the gateway spacing, when you come away from the harbor, is a little cramped for long and wide transport.
- Real Full Trailer Combination Driver -
- Real Full Trailer Combination Driver -
Looking at that picture as posted above, I am confused. That's not the only port that has that gate layout, but if there is a sliding gate to the right, then either the gate on the left should be open all the way (instead of getting in the way when exiting the port) and/or the gate in the middle is ... well... an oddity of design.
Trying to exit ports with this gate design is a right P.I.T.A. unless you exit on the wrong side (for everywhere but the UK in which case the issue is encountered when entering).
I'm not even going to mention the fun had with a wide load.
Trying to exit ports with this gate design is a right P.I.T.A. unless you exit on the wrong side (for everywhere but the UK in which case the issue is encountered when entering).
I'm not even going to mention the fun had with a wide load.
- n4gix.bill.leaming
- Posts: 1196
- Joined: 07 Aug 2013 18:22
- Donation rank:
- Location: Hammond, Indiana
- Contact:
If the road were angled to match the gate's angle, then the problem would be solved. The gates are angled to match the angle of the ticket booths.
Fr. Bill
Global Moderator
Interests: Gauge Programming - 3d Modeling for Milviz
Global Moderator
Interests: Gauge Programming - 3d Modeling for Milviz
-
- Information
-
Who is online
Users browsing this forum: No registered users and 0 guests