Invisible walls

[penguinaz]

So I finished enough of my map today to be able to test drive in it. So I loaded it into my profile and drove through it... but wait! THERE IS AN INVISIBLE WALL! SO I take an alternative route, and *SHOCK* there is another invisible wall... basically my map is filled with a bloody ton of invisible walls....

So I looked through the editor but didn't find anything suspicious. Can anyone point me in the right direction on this?

What I have noticed is that all the invisible walls are right where a terrain of Water start under the road.

[ETS2-User]

Tick no boundary on terrain and under bridges. If you type "g_colbox 1" in the console you'll be able to see all collision boxes, including invisible walls.

[09_KZ]

Can anyone point me in the right direction on this?

What I have noticed is that all the invisible walls are right where a terrain of Water start under the road.

I recently ran into this. Likely to cause here I think will understand

[penguinaz]

Thanks.
I will start placing water like that from now on

[Chris94_NOR]

I had a ton of invisible walls before in my map. I eventually found out what it was. It happens on 4-lane roads. On the 4-lane roads, be careful using the crash barrier called "crash_barrier.tmd". That is a pain in the ass.